Dranetz Xplorer Guide de l'utilisateur télécharger pdf (Page 79)

4-11

CH 4/ Instrument Settings

Communication

interface setup

(continued)

Action... Result...

STEP 2: Entering the correct IP

address settings will enable the

PX5 to communicate with the

network.

Prior to entering the IP setttings,

make sure that the PX5 is

connected to the computer

network via the Fiber optic to

Ethernet Adapter (P/N COMM-

OEA).

After you have determined the

proper IP address and settings,

proceed as follows:

• Type in your Ethernet IP

Address in the appropriate

fields. Use the numeric keypad

to enter the IP setting.

• Type in your Ethernet Subnet

Mask in the appropriate fields.

Use the numeric keypad to

enter the Subnet Mask setting.

• Type in your Gateway in the

appropriate fields. Use the

numeric keypad to enter the

Gateway setting.

When done entering IP settings,

press OK. Pressing OK will store

the values in the instrument.

Press Send to configure the

Ethernet adapter using the new IP

address settings. Follow the

instructions that appear on screen

to complete the IP setting

configuration procedure.

Press Cancel to ignore changes

and retain the previous IP

settings, no new values will be

stored in the instrument.

MARK159b

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 289 290

Commentaires sur ces manuels

Pas de commentaire

Dranetz Xplorer Guide de l'utilisateur Page 79

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Dranetz Xplorer