Dranetz Visa Guide de l'utilisateur télécharger pdf (Page 220)

C-4

Battery Pack Replacement

Introduction

The PowerVisa contains an easily replaceable internal battery pack. See Appendix D

for ordering information.

WARNING

Replace with Dranetz-BMI NiMH battery pack BP-PX5 only.

ADVERTENCIA

Reemplace con batería Dranetz-BMI NiMH BP-PX5 solamente.

AVERTISSEMENT

Remplacer par la batterie Dranetz-BMI NiMH BP-PX5 exclusivement.

WARNUNG

Nur mit Dranetz-BMI NiMH BP-PX5 Batteriesatz auswechseln.

NOTE

During normal operation, the battery pack will be slightly warm to the touch.

Procedure

Follow these steps to replace the battery pack.

Continued on next page

Step Action

1 Press the PowerVisa power button to off.

2 Turn off power to the circuit being measured.

3 Disconnect voltage and current probes from the circuit and the

PowerVisa is rear panel.

4 On the bottom of the PowerVisa, push the tab to release the battery

cover. Refer to the diagram shown on page C-5.

5 Remove the cover.

6 Pull up on removal strap and remove battery pack.

7 Insert the new pack into the compartment making sure to observe

polarity markings.

8 Replace the cover and press down until it latches closed.

9 Discard the old battery pack in accordance with Environmental

Protection Agency (EPA) regulations.

10 Press the PowerVisa power button to on.

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 273 274

Pas de commentaire

Dranetz Visa Guide de l'utilisateur Page 220